GenParts 06M19P1 is a line of durable diesel engine, low noise and fuel efficient. Fixed speed of 1500 rpm is used exclusively for small generators from 10 to 16KVA continuously.
Basic technical data:
| Number of cylinders | 4 |
| Cylinder arrangement | In-line |
| Combustion Cycle | Four stroke, compression ignition |
| Cooling medium | Liquid |
| Method of air aspiration | Nature inhaling air |
| Compression ratio | 17:1 |
| Bore | 90 mm |
| Stroke | 100 mm |
| Displacement | 2.54L |
| Direction of rotation | Anti-clockwise viewed on flywheel |
| Total weight (engine only) | (Dry) 220±10 kg |
| Overall dimensions | |
| Height | 752mm |
| Length | 558mm |
| Width | 686mm |
| Ratings | |
| Steady state speed stability at constant load | 5% |
| Operating point | |
| Engine speed | 1500 rpm |
| Engine power(Gross) | 30 Hp (Standby) |
| Static injection timing | 15~20℃A before the TDC |
| Sound level | |
| Sound pressure level 1500 rev/min | ≤ 95 dBA |
| Test Conditions | |
| Air temperature | 25 °C |
| Barometric pressure | 100kPa |
| Relative humidity | 30% |
| Air inlet Restriction at maximum power (nominal) | 5kPa |
| Exhaust back pressure (nominal) | 6kPa |
| Cooling system | |
| Total coolant capacity (engine only) | 6L |
| Maximum top tank temperature | 99°C |
| Thermostat operating range | 76~95 °C |
| Coolant intake size | Φ52mm |
| Coolant outlet size | Φ48mm |
| Lubrication system | |
| Lubricating oil type | CF-4 |
| Lubricating oil capacity | 8L |
| Lubricating oil temperature maximum to bearings | 115°C |
| Oil Pressure @ Idle Speed | ≥98kPa |
| @ Governed Speed | 294~490kPa |
| Maximum engine operating angles Front up,front down/right side or left side | 20°/15° |
| Fuel system | |
| Fuel oil type | 0# or 10# |
| Type of injection system | Direct injection |
| Fuel injection pump | Inline pump |
| Fuel consumption | 230 (g/kWh) |
| Governor type | Mechanical |
| Electrical system | |
| Alternator | 12volts with integral regulator |
| Starter motor | 12volts |
| Recommended Battery Capacity | 55Ah |
| Dater shown above represent gross engine performance capabilities and corrected in accordance with ISO-3046 conditions of 100kPa(29.53in Hg) barometric pressure [110m (361ft) altitude],25℃(77℉) air inlet temperature,and relative hunidity of 30%with No.2 diesel or a fuel corresponding to ASTM D2.
Derates shown are based on 15 in H2O air intake restriction and 2 in Hg exhaust back pressure. The fuel consumption data is based on No.2 diesle fuel weight at 0.85 kg/litre(7.1 lbs/U.S.gal).Power output curves are based on the engine operating with fuel system,water pump and lubricating oil pump;not included fan,optional equipment and driven components. |
|
|
|
*Specifications are subject to change without notice
Đánh giá
Chưa có đánh giá nào.